Accelerate the diversified development of automation modes in the rubber diaphragm industry, improve the speed of other interfaces in the rubber diaphragm industry, reduce market demand in the rubber diaphragm industry, achieve market competition in the rubber diaphragm industry, and reduce market demand in the rubber diaphragm industry.
Quick display capacity: 0ml/min~0C~60mm Upper chute: 0045C Volume: 95K/16K Suitable for freezing or for wine, dilute acid, wine, jam, apples, chocolate, etc.
According to the customer’s preference, it can be selected into pneumatic diaphragm pumps and electric diaphragm pumps. Pneumatic diaphragm pumps are a new type of conveying machinery that uses compressed air as the power source. For various corrosive liquids, liquids with particles, high viscosity, volatile, flammable, and highly toxic liquids, they can be pumped and absorbed completely.
The rubber diaphragm is molded from natural rubber, and artificial additives are added to the rubber to improve the chemical resistance and bending performance of the diaphragm.
When pressing the rubber diaphragm, a nylon woven mesh is placed inside the rubber to disperse stress and strengthen the diaphragm.
Neoprene. Low cost ordinary diaphragm for non corrosive liquids.
Fluorinated rubber (Viton). It has a good bending life under high temperature conditions, used for transporting aromatic or chlorinated hydrocarbons and acidic liquids.
● Toughness: QBY rubber lined diaphragm pump, with a maximum temperature of less than 220 ° C, can replace 413 and 240 ° C.
If there is dirt entering the compressed air, it will affect the normal start of the pump. It is recommended that users install pneumatic triplets.
When pumping media that is prone to freezing, a valve should be installed at the inlet of the pump. When the pump is stopped, the valve should be closed first, and then the pump should be turned on for a few minutes until the pump body media is completely drained to avoid difficulties in starting the pump next time.
When replacing the diaphragm, it is necessary to clean the connecting rod and lead sleeve inside the pump, and do not damage the white PTFE sealing ring. Install it as is before use.
● A 3000t oil tanker shall be discharged with a fixed screw pump after recovering the oil from the bottom of the oil tanker bunker. At least 50t oil shall be left between the bulkheads of the bunker. If a diaphragm pump with a large displacement is used, good results can be achieved.
Liquefied gas pump rooms and laboratories discharge waterlogging. Due to the low terrain and being a first level fire zone, diaphragm pumps are used with less displacement to quantitatively reduce the gas to the lowest point.
In addition, this pump is used for refining and transferring naphthenic acid, loading salt machines, kerosene, acetic acid, Chongqing single salt separators, and gas-liquid two-phase wastewater treatment.
Learn more>1200MW! The lifting of the rotor of generator 3 at Suwalong Hydropower Station was successfully completed.
