Take you to understand the needs of rolling diaphragm manufacturers! Vibration diaphragm pump, also known as control pump, is determined based on the size of the diaphragm pump. The diaphragm pump uses compressed air as the power source, which can pump and absorb various corrosive liquids, liquids with particles, high viscosity, volatile, flammable, and highly toxic liquids.
Diaphragm pump, also known as control pump, is the main type of actuator that receives control signals from modulation units and uses power operation to change fluid flow. Diaphragm pumps generally consist of an actuator and a valve. Using compressed air, nitrogen, or natural gas as power. The main directional (pneumatic) control valve distributes compressed air to the gas chamber and applies uniform pressure to the inner surface of the diaphragm.
The internal structure of the diaphragm pump has approximately 4 chambers, mainly controlled by the control system. Form a right angle to the inner wall of the diaphragm, and the discharged gas is discharged from the other side of the pump through the guide port of the gas valve assembly.
The diameter of the exhaust channel joint of the diaphragm pump, the gas pressure difference behind the suction pipe, and the electrical signal of the control instrument cause the electromagnetic valve armature to move back. The vent hole of the rear air chamber opens, and the rear air chamber rapidly loses pressure. The diaphragm component moves back, and compressed air is sprayed through the valve output port, leaving the electromagnetic valve in an “open” state.
Lack of understanding of the internal structure of the diaphragm pump and insufficient wording resulted in overall burning, etching, water supply, air explosion, burning, welding flux, packaging plant, etc.
The connection between the connecting rod shaft and the impeller is brought in by a metal hard seal. If there are any applications that cannot be done, please feel free to do so at any time“
In addition, please try to understand the size and tension of the pneumatic diaphragm pump. If you can also use a label to indicate the material dosage measurement, we will provide a detailed introduction below.
The air pressure of the pneumatic diaphragm pump can only be at the air supply pressure of 06, 24, 36, and the solenoid valve can be equipped with a low electrical content, or other
; If you can choose a pneumatic diaphragm pump or write a program, you can make system adjustments according to your requirements to ensure the normal operation of the pneumatic diaphragm pump.
Flowmeter: 03-07, AC220V, AC110V, AV220V, DC24V, DC36V, DC72V, DC110V, etc.
Five types of diaphragm pumps can be divided into three types based on the angle of valve inlet and outlet and the form of air inlet: 1) Engineering plastics: cast iron, cast steel, stainless steel, alloy: polytetrafluoroethylene, polytetrafluoroethylene.
