The most technologically advanced rubber diaphragm factory has the most comprehensive equipment models, and the most important rubber diaphragm plate price meets the requirements of compressed air and manual spraying in the lowest working environment.
After being torn or abandoned, it can instantly shrink and undergo no change, and is fireproof, waterproof, dustproof, and environmentally friendly in the world.
The failure of the rubber diaphragm is a common fault of the bag filter, which directly affects the cleaning effect. This equipment belongs to the external filter type, with a skeleton inside the bag. It is necessary to check whether the parts that fix the filter bag are loose and whether the tension of the filter bag is appropriate. Is the support frame smooth to prevent wear on the filter bag. Compressed air is used for ash removal. Therefore, it is required to remove oil mist and water droplets, and the oil water separator must be cleaned regularly to prevent movement mechanism failure and filter bag blockage.
Regularly check the operation of control valves, pulse valves, and timers. For example, the rubber diaphragm of the pulse valve is the “switch” of the blowing air circuit of the pulse bag dust collector cleaning system, and the electromagnetic valve diaphragm inside the valve body is the key to its normal operation. The pulse control instrument controls the vibration of the pulse valve diaphragm inside the valve body to inject pulse “impulse” into the street to clean the dust. The area of the rear control diaphragm is larger than the area of the front control, and the pneumatic force is large. Place the diaphragm in a critical position. The pulse control instrument inputs an electrical signal to activate the electromagnetic pilot head and open the unloading hole. The pressure gas behind the diaphragm is quickly discharged. The pressure gas in the front control of the diaphragm lifts the diaphragm, opens the electromagnetic pulse valve channel and sprays it into the street. The electrical signal disappears, and the spring of the electromagnetic pilot head immediately resets and closes the unloading hole. The gas pressure and spring force in the back control of the diaphragm close the channel, and the electromagnetic pulse valve stops blowing. The resistance hole on the diaphragm acts as a resistance to the airflow when the pilot head moving column is lifted and the gas pressure is unloaded. When the unloading is closed, Quickly fill the pressure gas into the rear chamber, causing the diaphragm to close the channel and stop blowing< eod>。
