The declaration process for the export rolling diaphragm sequentially follows the working principle of the water film dust collector (reversing valve), reversing valve, and pipeline execution mechanism. The pump is driven by a motor using Lanbao, LITON, GO jig, timing, and manual reversing valves, and the valve plate is driven by the air cylinder of the control cabinet, enabling the valve to achieve remote and offline adjustment of the medium, achieving fault, adjustment, and shock absorption.
The reliability and fluid control performance of the pipeline control instrument and mechanism detection enable the pipeline control system to fully recover from the appropriate medium, thus achieving true water supply and automatic operation of the self priming pump in the pipeline.
The use of a pneumatic tank greatly reduces the air volume, increases the motor volume, prolongs the pipe diameter, and reduces pipeline waste. The shaft seal inputs the interface of the solenoid valve, and the gas released by the solenoid valve is taken from the pipeline outlet or outlet, inserted into the output port of the solenoid valve to generate a right angle Electromagnetic pulse valve of the Electromagnetic pulse valve.
Design technology and performance inspection of DC solenoid valve system ordered by Zhejiang customers: AMF-Z-40S Electromagnetic pulse valve’s working principle: Z-type Electromagnetic pulse valve is the “switch” of the blowing air path of the dust cleaning system of the pulse bag filter, and the diaphragm in the valve body is the key to its normal operation. The pulse controller controls the diaphragm vibration in the valve body to inject pulse “impulse” into the street for dust cleaning. The area of the diaphragm rear control is larger than that of the front control, The pressure acting force is high. Place the diaphragm in a critical position. The pulse control instrument inputs an electrical signal to activate the electromagnetic pilot head and open the unloading hole. The pressure gas behind the diaphragm is quickly discharged. The pressure gas in the front control of the diaphragm lifts the diaphragm, opens the channel of the Electromagnetic pulse valve to inject into the street, and the electrical signal disappears. The spring of the electromagnetic pilot head immediately resets the moving column to close the unloading hole. The pressure of the gas in the back control of the diaphragm and the force of the spring close the channel. The Electromagnetic pulse valve stops the injection, and the resistance hole on the diaphragm acts as a resistance to the airflow when the moving column of the pilot head lifts and the gas pressure unloads. When the unloading is closed, Quickly fill the pressure gas into the rear chamber, causing the diaphragm to close the channel and stop blowing< Eod>.