Rolling diaphragm to share with everyone a practical tip, electric diaphragm pumps can work under high pressure and can also provide high pressure, so the coefficient is low and easy to obtain.
The main feature of the diaphragm pump diaphragm is that it does not need to be filled with water, and can not only pump flowing liquid but also transport some easily flowing media. The suction head is up to 7m, the lift is up to 50m, and the outlet pressure is ≥ 6kgf.
Without the need for irrigation and water diversion, it can pump flowing liquid and transport some easily flowing media, with a high suction head and a lift of up to 50m. In short, the weight of the pump body is less than or equal to that of my grade.
The flow is spacious and the passing performance is good, allowing the maximum particle diameter to reach 10mm. When pumping mud and impurities, there is minimal wear on the pump;
The head and flow rate can be adjusted steplessly through the opening of the air valve (the air pressure can be adjusted between 1-7kg/depth).
Convenient to use, reliable in operation, and easy to open and close gas valves for start and stop. Even if there is no medium operation for a long time or sudden shutdown due to unexpected circumstances, the pump will not be damaged. Once overloaded, the pump will automatically stop, with self-protection performance. When the load returns to normal, it can automatically start and run;
The pump has a simple structure with few vulnerable parts, and is easy to install and maintain. The medium conveyed by the pump will not come into contact with moving parts such as the gas distribution valve and connecting rod. The transmission volume of materials can be guaranteed through the reducer, reducing or replacing normal products;
This pump does not require oil lubrication, and even if it is idling, the system will not be affected. This is a characteristic of diaphragm pumps. In addition, the pump also has good idling because the working principle of pneumatic diaphragm pumps is not a problem.
The sealing surfaces between the valve body and the connecting parts are 10, 25, 40, 60, 75, and 150;
The valve cover component can be seen as an external filter type at the bottom, and the inner side of the diaphragm is a clean air chamber, which can be completely sealed to reach the discharge area.
The valve cover material is free of defects, and the main solutions are diaphragm type, compressed air valve, vacuum oil valve, diaphragm type, O-ring, and type. You can see that in any position, pneumatic diaphragm pump can solve the problem.
Check if there is any damage to the valve cover components, leakage of the packing box, damage to the diaphragm pump, gasket, and the following diaphragms below, or if the adhesive at the connection cannot stick, friction causes the diaphragm to be in the closed position.
Valve cover accessories are free from defects, mainly including valve covers, valve cover components, valve cover accessories, diaphragm valves, seals, rubber diaphragm plates, valve stems, vehicles, spindle repair sleeves, pressure heads, lower parts, valve covers, papermaking, pharmaceuticals, food, coal mines, power plants, ash depots, steel mills, coking, AISI, South Korea, Shanxi, South Korea, Hong Kong, equipment, marketing services, etc.
