The rubber diaphragm product represents a new and upgraded version of the internal threaded diaphragm. The introduction of new generation materials and configuration products such as pneumatic regulators and electric regulators inside the pump has formed a huge improvement and development.
Industrial accessories are suitable for different working conditions, such as workpiece surface area (defined), surface wear (calculated), surface electroplating, parts, etc.
Production customization, Dongguan sealing rings, automotive machinery, electronic machinery, wires and cables, brass, long neck bus, brass, Teflon, bucket elevator, and paint level attention.
Before installation, it is necessary to ventilate and clean the debris inside the gas supply pipeline. During installation, pay attention to the direction of gas flow and whether the connecting pipe is correct.
Check if the air valve is broken and adjust the pressure evenly, otherwise it may affect the service life of the air valve.
● Check whether the pulse dust removal controller of the dust remover can blow normally. If there is any problem, it can tilt to the inside of the equipment or up the equipment in time.
Check the operation of pulse valves and timers, as well as any debris inside the valve body or pipeline. If any air leakage is found, it should be promptly eliminated.
● Check whether the inertial valve reducer, timer and other reducers on the pulse valve and dust remover blow normally. If they are damaged, they can be replaced in time.
Check if the pulse valve and air bag are in good condition. If there are foreign objects such as impurities and moisture inside, please replace them in a timely manner. If there are foreign objects such as impurities and moisture inside, please replace them in a timely manner.
Check if the pulse valve and air bag are in good condition. If there are impurities, moisture, and other foreign objects inside, please replace them in a timely manner.
Check if the air bag is blocked. If there are impurities, moisture, and other foreign objects inside, please replace, assemble, install, and debug them in a timely manner.
Check the flange connections of the dust collector and pass them through 80mm. Select similar connections and regularly check whether the seal is blocked.
Check the pulse valve and timer, set the reversing, and carry out appropriate temperature and ash cleaning devices.
If dust removal is required, first remove the dust device for dust removal. Clean the dust at 900Pa to remove contamination.
● Cleaning cycle: Cleaning cycle with low resistance. The cleaning intensity can be used for detecting and removing dust collector faults.
Maintenance and bag replacement can be used for detection: In the design stage, there are: dust containing gases entering, which can generate strong low pressure due to temperature changes. The manufacturer of the bag filter suggests that the filter bag fitting room can be adjusted to a variable level in 1992.
