Rubber diaphragm BBS forum and global exchange center technology factory have profound AI computing capabilities, and plastic concept companies are full of great wisdom and innovation capabilities.
The size of the rubber diaphragm must add 300, 1, 60, 100, etc. to the elasticity of the ellipse, and then press 3, 4, 10, 16, 10, 25, X, Y, 50, 150, 250mm. The existing insulation diaphragm can measure ethylene propylene, NR, 173, 220, 110, 24, 80, 120, 150, NPT, etc.
The rubber diaphragm is in the “closed” state and must be pushed by compressed air (or strong force) to install the passage in the groove. It can buffer against impact and instantaneous thermal suction (or expansion), and the suitable temperature is -25 ° C.
Installation is more convenient, without worrying about environmental issues, which is both economical and practical, while ensuring safety and longer service life;
Only corresponding measuring flow, pressure, and protective devices need to be set up to ensure that the electrical signal is high-speed or the power supply is not dangerous, and it is more reliable.
There is no need for preprocessing. If any attachment or weir is installed directly at any position, the device only needs to set the corresponding measurement method to control the operating parameters.
The operating parameters do not require a pressure switch for the position, resulting in changes in flow rate during flammable and hazardous processes.
The switch model is used for the direction of the S-type metering pump, higher than 101, 180, etc. Through experiments, it has been found that the above digital integrated circuit is only used by the owner.
The pressure of the equipment is between 01MPa and 07MPa, and the medium is air that has undergone oil and water removal treatment.
The pulse electromagnetic valve should be able to operate normally after withstanding a vibration with a frequency of 20Hz, a full amplitude of 2mm, and a duration of 30min.
● In case of overload, the service life of the solenoid valve diaphragm shall be changed in time after the 10mm right angle and Electromagnetic pulse valve diaphragm are damaged.
After a long period of operation, the diaphragm in the solenoid valve body vibrates very little, but the diaphragm is still moving. Under normal working conditions, the insulation resistance of the electromagnetic coil to the shell should be greater than 1M Ω.
When using 015mm, 3. Under storage pressure, the service life of the diaphragm should be greater than 6mm.
Under specified environmental conditions, the insulation resistance of the electromagnetic coil to the shell should be greater than 1M Ω.
Under the condition of room temperature ranging from 5 degrees to 35 degrees and relative humidity not exceeding 85%, the electromagnetic coil can withstand a voltage of 50Hz and 250V to the shell for 1 minute without any breakdown phenomenon.
● Under normal use conditions, the cumulative service life of Electromagnetic pulse valve diaphragm shall be more than 800000 times.
